56G QSFP+ Active Optical Cables AOC Hot Plugable 38pin Connector
56G QSFP+ Active Optical Cable AOC JNP-56G-AOC-3M Juniper Networks Compatible
Description:
OLSQ85XA-CDM3 is designed so that 56GbE devices are designed with very high port density based on electrical and mechanical specifications.
Product Features
* Fully RoHS Compliant
* Full channel operating up to 56.1Gb/s
* Hot plugable 38pin connector
* Cable length up to 3m
* Low power consumption: ＜1.5W
* 0℃ to 70℃ operating wide temperature range
* Single +3.3V±5% power supply
* Digital Monitoring feature
* Metal enclose for lower EMI
Absolute Maximum Ratings
| Parameter | Symbol | Min. | Max. | Unit | Note |
| Supply Voltage | Vcc | -0.5 | 3.6 | V | |
| Storage Temperature | TS | -10 | 70 | °C | |
| Relative Humidity | RH | 5 | 85 | % | |
Note: Stress in excess of the maximum absolute ratings can cause permanent damage to the transceiver.
General Operating Characteristics
| Parameter | Symbol | Min. | Typ | Max. | Unit | Note |
| Data Rate | DR | 1.25 | 14.025 | | Gb/s | |
| Supply Voltage | Vcc | 3.13 | 3.3 | 3.47 | V | |
| Supply Current | Icc5 | | | 450 | mA | |
| Operating Case Temp. | Tc | 0 | | 70 | °C | |
Optical Characteristics (TOP(C) = 0 to 70 ℃, VCC = 3.13 to 3.47 V)
| Parameter | Symbol | Min. | Typ | Max. | Unit | Note |
| Transmitter |
| Operating Wavelength | λ | 840 | 850 | 860 | nm | |
| Output Optical Eye | Compliant with IEEE 0802.3ae |
| Receiver |
| Operating Wavelength | | 840 | | 860 | nm | |
Electrical Characteristics (TOP(C) = 0 to 70 ℃, VCC = 3.13 to 3.47 V)
| Parameter | Symbol | Min. | Typ | Max. | Unit | Note |
| ModSelL-Module Select | VOL | 0 | | 0.8 | V | |
| ModSelL-Module Unselect | VOH | 2.5 | | VCC | V | |
| LPMode-Low Power Mode | VIL | 0 | | 0.8 | V | |
| LPMode-Normal Operation | VIH | 2.5 | | VCC+0.3 | V | |
| ResetL-Reset | VIL | 0 | | 0.8 | V | |
| ResetL-Normal Operation | VIH | 2.5 | | VCC+0.3 | V | |
| ModPrsL-Normal Operation | VOL | 0 | | 0.4 | V | |
| IntL-Interrupt | VOL | 0 | | 0.4 | V | |
| IntL-Normal Operation | VOH | 2.4 | | VCC | V | |
| Active cable input electrical characteristics |
| Differential Data Input Voltage | VIH-VIL | 200 | | 1600 | mVpp | 1 |
| Differential Input Impedance | RIN | 90 | 100 | 110 | Ω | |
| TX-Disable Input Voltage-Low | VIL | 0 | | 0.8 | V | 2 |
| TX-Disable Input Voltage-High | VIH | 2.0 | | VCC | V | 2 |
| TX-Fault Output Voltage-Low | VOL | 0 | | 0.8 | V | 3 |
| TX-Fault Output Voltage-High | VOH | 2.0 | | VCC | V | 3 |
| Active cable output electrical characteristics |
| Differential Data Output Voltage | VOH- VOL | 350 | | 800 | mV | 1 |
| Differential Output Impedance | ROUT | | 100 | | Ω | |
| LOS-Asserted Output Voltage-Low | VOL | 0 | | 0.8 | V | 3 |
Notes:
1. Average power figures are informative only, per IEEE 802.3ae.
2. Measured at the BER less than 1E-12, back to back. The measure pattern is PRBS 231-1 with worst ER=4.5@ 10.3125Gb/s.
3. Internal AC coupled
4. TX-Disable has an internal 4.7KΩ to 10 KΩ pull-up to VccT
5. Measure with 4.7KΩ pull-up to Vcc on host board
Cable Mechanical Specifications
| Parameter | Value | Units |
| Diameter | 3 | Mm |
| Minimum bend radius | 30 | Mm |
| Length tolerance | Length < 1 m: +5 /-0 | Cm |
| 1 m ≤length ≤ 4.5 m: +15 / -0 | Cm |
| 5 m ≤length ≤ 14.5 m: +30 / -0 | Cm |
| Length≥15.0 m +2% / -0 | m |
| Cable color | Orange(OM2),Aqua(OM3),Megenta(OM4) | |
Ordering Information
| Part Number | Description |
| OLSQ85XA-CDM3 | QSFP+, up to 56Gb/s, AOC, 0~70℃, with Digital Diagnostic Monitor |
Product Tags:
|
|
56G QSFP+ Active Optical Cables AOC Hot Plugable 38pin Connector Images
|
